Non-Standard Bolts

Dobrodošli na moj blog

17.04.2018.

There are different types of expansion bolts

While wood door frames are commonly used for doors in walls made from drywall or plaster, metal ones are generally used in masonry walls. Steel is less resistant to rot and decay, standing up to moisture and fluctuations in temperature better than a wood frame could. Metal frames are generally put in place before the masonry wall is built, but sometimes there is a need to install one later, into an existing masonry entryway. In these cases, special anchors are used to install the frame. Once a steel frame is anchored into a masonry door frame, a door can be attached in the usual manner.Selecting a Steel Door FrameIt is important to choose one that is appropriate for use in masonry walls. Steel frames that are designed for use in masonry walls will have a 4-inch header. This is necessary so that the top of the door frame will line up with the masonry. The overall thickness of the walls must be measured, since the frame's jamb depth needs to equal this thickness.

The size of the frame is also important, and the overall size should be 1/2-inch smaller than the measured width of the door opening, and 1/4-inch shorter, so that the frame will fit properly into the opening in the masonry wall. The metal door frame should already have been punched and dimpled during the manufacturing process so that it can be used with wall anchors.Installing the Steel Door FrameIn order to drill the holes at the proper location on the masonry door opening, you need to carefully measure the height of each of the frame's pre-manufactured dimpled areas. Mark these locations on the inside of the masonry door opening, and then use a masonry bit to drill all the hole locations that you marked. Then, place the metal door frame inside the opening and line it up with the holes that were drilled. Use an expansion bolt for each of the frame's dimples, which will attach the door frame securely to the masonry door opening.

There are different types of expansion bolts, so be sure to follow the instructions for the type you purchase, as some of them are designed to be hammered into place while others must be driven into place by using an impact gun.Planning a Steel Door Frame for Masonry Walls Which Haven't Been BuiltIf the masonry wall hasn't been built yet, you can install the door frame in advance. Select a frame Non-standard shaped bolts with a jamb depth that will equal that of the finished walls. There should be wire or T-strap anchors on it. Using the plans for the wall as a guide, set the frame in the spot where the door opening will be, and measure until the frame is completely level, using wooden shims if necessary. Using the sill anchors at the jamb's base, fasten the steel frame to the floor with concrete bolts. Braces can be used to keep the frame properly positioned until the masonry walls are constructed. When the walls are built, the wire or T-strap anchors on the frame will be anchored between the rows of masonry to hold it secure.

<< 04/2018 >>
nedponutosricetpetsub
01020304050607
08091011121314
15161718192021
22232425262728
2930

link

MOJI FAVORITI
-

BROJAČ POSJETA
275

Powered by Blogger.ba